298 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
no serial timeout
This command sets the maximum connect time (in minutes) without console activity.
Format
no serial timeout
Mode Line Config
show serial
This command displays serial communication settings for the switch.
Format
show serial
Modes Privileged EXEC
User EXEC
Serial Port Login Timeout (minutes) The time, in minutes, of inactivity on a Serial port
connection, after which the Switch will close the connection. Any numeric
value between 0 and 160 is allowed, the factory default is 5. A value of 0 dis-
ables the timeout.
Baud Rate (bps) The default baud rate at which the serial port will try to connect. The avail-
able values are 1200, 2400, 4800, 9600, 19200, 38400,57600, and 115200
baud. The factory default is 9600 baud.
Character Size (bits) The number of bits in a character. The number of bits is always 8.
Flow Control Whether Hardware Flow-Control is enabled or disabled. Hardware Flow Con-
trol is always disabled.
Stop Bits The number of Stop bits per character. The number of Stop bits is always 1.
Parity Type The Parity Method used on the Serial Port. The Parity Method is always
None.
Telnet Commands
This section describes the commands you use to configure and view Telnet settings. You can
use Telnet to manage the device from a remote management host.
ip telnet server enable
Use this command to enable Telnet connections to the system and to enable the Telnet Server
Admin Mode. This command opens the Telnet listening port.
Default enabled
Format
ip telnet server enable
Mode Privileged EXEC
no ip telnet server enable
Use this command to disable Telnet access to the system and to disable the Telnet Server
Admin Mode. This command closes the Telnet listening port and disconnects all open Telnet
sessions.
To Next Page
Loading...
