D-Link DWL-3500AP

SNMP Commands 313
7 Management Commands
NOTE: This command may not be available on all platforms.
Default enabled
Format
snmp-server enable traps bcaststorm
Mode Global Config
no snmp-server enable traps bcaststorm
This command disables the broadcast storm trap. When enabled, broadcast storm traps are sent
only if the broadcast storm recovery mode setting associated with the port is enabled.
NOTE: This command may not be available on all platforms.
Format
no snmp-server enable traps bcaststorm
Mode Global Config
snmp-server enable traps linkmode
This command enables Link Up/Down traps for the entire switch. When enabled, link traps are
sent only if the Link Trap flag setting associated with the port is enabled. See “snmp trap link-
status” on page 315.
Default enabled
Format
snmp-server enable traps linkmode
Mode Global Config
no snmp-server enable traps linkmode
This command disables Link Up/Down traps for the entire switch.
Format
no snmp-server enable traps linkmode
Mode Global Config
snmp-server enable traps multiusers
This command enables Multiple User traps. When the traps are enabled, a Multiple User Trap
is sent when a user logs in to the terminal interface (EIA 232 or Telnet) and there is an existing
terminal interface session.
Default enabled
Format
snmp-server enable traps multiusers
Mode Global Config
no snmp-server enable traps multiusers
This command disables Multiple User traps.
Format
no snmp-server enable traps multiusers
Mode Global Config