VLAN Commands 59
2 Switching Commands
You should create the referenced VLAN before you create the protocol-based VLAN except
when you configure GVRP to create the VLAN.
Default none
Format
protocol vlan group all <groupid>
Mode Global Config
no protocol vlan group all
This command removes all interfaces from this protocol-based VLAN group that is identified
by this
<groupid>.
Format
no protocol vlan group all <groupid>
Mode Global Config
vlan pvid
This command changes the VLAN ID per interface.
Default 1
Format
vlan pvid <1-3965>
Mode Interface Config
no vlan pvid
This command sets the VLAN ID per interface to 1.
Format
no vlan pvid
Mode Interface Config
vlan tagging
This command configures the tagging behavior for a specific interface in a VLAN to enabled.
If tagging is enabled, traffic is transmitted as tagged frames. If tagging is disabled, traffic is
transmitted as untagged frames. The ID is a valid VLAN identification number.
Format
vlan tagging <1-3965>
Mode Interface Config
no vlan tagging
This command configures the tagging behavior for a specific interface in a VLAN to disabled.
If tagging is disabled, traffic is transmitted as untagged frames. The ID is a valid VLAN
identification number.
Format
no vlan tagging <1-3965>
Mode Interface Config
vlan association subnet
This command associates a VLAN to a specific IP-subnet.
To Next Page
Loading...
