RADIUS Commands 321
7 Management Commands
no radius server timeout
This command sets the timeout value to the default value.
Format
no radius server timeout
Mode Global Config
authorization network radius
Use this command to allow the switch to accept VLAN assignment by the RADIUS server.
Default disabled
Format
authorization network radius
Mode Global Config
no authorization network radius
Use this command to prohibit the switch from accepting VLAN assignment by the RADIUS
server.
Format
authorization network radius
Mode Global Config
show radius
This command is used to display the various RADIUS configuration items for the switch as
well as the configured RADIUS servers. If the optional token 'servers' is not included, the
following RADIUS configuration items are displayed.
Format
show radius [servers]
Mode Privileged EXEC
Primary Server IP Address The configured server currently in use for authentication.
Number of configured servers The configured IP address of the authentication server.
Max number of retransmits The configured value of the maximum number of times a
request packet is retransmitted.
Timeout Duration The configured timeout value, in seconds, for request re-transmissions.
Accounting Mode Yes or No.
If you use the
[servers] keyword, the following information displays:
IP Address IP address of the configured RADIUS server.
Port The port in use by this server.
Type Primary or secondary.
Secret Configured Yes / No.
Message Authenticator The message authenticator attribute for the selected server, which
can be enables or disables.
To Next Page
Loading...
