D-Link DWL-3500AP

106 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
Format no lldp transmit
Mode Interface Config
lldp receive
Use this command to enable the LLDP receive capability.
Default disabled
Format
lldp receive
Mode Interface Configuration
no lldp receive
Use this command to return the reception of LLDPDUs to the default value.
Format
lldp receive
Mode Interface Configuration
lldp timers
Use this command to set the timing parameters for local data transmission on ports enabled for
LLDP. The
<interval-seconds> determines the number of seconds to wait between
transmitting local data LLDPDUs. The range is 1-32768 seconds. The
<hold-value> is the
multiplier on the transmit interval that sets the TTL in local data LLDPDUs. The multiplier
range is 2-10. The
<reinit-seconds> is the delay before re-initialization, and the range is 1-0
seconds.
Default interval—30 seconds
hold—4
reinit—2 seconds
Format
lldp timers [interval <interval-seconds>] [hold <hold-value>]
[reinit <reinit-seconds>
]
Mode Global Config
no lldp timers
Use this command to return any or all timing parameters for local data transmission on ports
enabled for LLDP to the default values.
Format
no lldp timers [interval] [hold] [reinit]
Mode Global Config
lldp transmit-tlv
Use this command to specify which optional type length values (TLVs) in the 802.1AB basic
management set are transmitted in the LLDPDUs. Use
sys-name to transmit the system name
TLV. To configure the system name, see See “snmp-server” on page 310. Use
sys-descto
transmit the system description TLV. Use
sys-cap to transmit the system capabilities TLV.