Captive Portal Global Commands 205
4 Wireless Commands
statistics interval
Use this command to configure the interval at which statistics are reported to the cluster
controller. The
<interval> variable is the reporting interval, which is a number in the range of
15-3600 seconds.
Default 120
Format
statistics interval <interval>
Mode Captive Portal Config Mode
Example:
The following shows an example of the command.
(Switch)(Config-CP) #statistics interval 200<cr>
no statistics interval
Use this command to set the statistics interval to the default value.
Format
no statistics interval <interval>
Mode Captive Portal Config Mode
Example:
The following shows an example of the command.
(Switch)(Config-CP) #no statistics interval<cr>
authentication timeout
This command configures the authentication timeout. If the captive portal user does not enter
valid credentials within this time limit, the authentication page needs to be served again in
order for the client to gain access to the network. The
<timeout> variable is the authentication
timeout, which is a number in the range of 60-600 seconds.
Default 300
Format
authentication timeout <timeout>
Mode Captive Portal Config Mode
no authentication timeout
This command configures sets the authentication timeout to the default value.
Format
no authentication timeout
Mode Captive Portal Config Mode
show captive-portal
This command reports status of the captive portal feature.
Format
show captive-portal
Mode Privileged EXEC
Administrative Mode Shows whether the CP is enabled.
To Next Page
Loading...
