EasyManua.ls Logo

D-Link DWL-3500AP

D-Link DWL-3500AP
344 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Static MAC Filtering 95
2 Switching Commands
Source Port The port, which is configured as mirrored port (source port) for the session
identified with
<session-id>. If no source port is configured for the ses-
sion then this field is blank.
Type Direction in which source port configured for port mirroring.Types are tx
for transmitted packets and rx for receiving packets.
Static MAC Filtering
The commands in this section describe how to configure static MAC filtering.
macfilter
This command adds a static MAC filter entry for the MAC address <macaddr> on the VLAN
<vlanid>. The value of the <macaddr> parameter is a 6-byte hexadecimal number in the
format of b1:b2:b3:b4:b5:b6. The restricted MAC Addresses are: 00:00:00:00:00:00,
01:80:C2:00:00:00 to 01:80:C2:00:00:0F, 01:80:C2:00:00:20 to 01:80:C2:00:00:21, and
FF:FF:FF:FF:FF:FF. The
<vlanid> parameter must identify a valid VLAN. You can create up
to 100 static MAC filters.
Format
macfilter <macaddr> <vlanid>
Mode Global Config
no macfilter
This command removes all filtering restrictions and the static MAC filter entry for the MAC
address
<macaddr> on the VLAN <vlanid>. The <macaddr> parameter must be specified as a
6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The
<vlanid> parameter must identify a valid VLAN.
Format
no macfilter <macaddr> <vlanid>
Mode Global Config
macfilter addsrc
This command adds the interface to the source filter set for the MAC filter with the MAC
address of
<macaddr> and VLAN of <vlanid>. The <macaddr> parameter must be specified as
a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The
<vlanid> parameter
must identify a valid VLAN.
Format
macfilter addsrc <macaddr> <vlanid>
Mode Interface Config
no macfilter addsrc
This command removes a port from the source filter set for the MAC filter with the MAC
address of
<macaddr> and VLAN of <vlanid>. The <macaddr> parameter must be specified
as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The
<vlanid> parameter
must identify a valid VLAN.

Table of Contents

Other manuals for D-Link DWL-3500AP

Related product manuals