D-Link DWL-3500AP

326 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
timeout
Use the timeout command in TACACS Configuration mode to specify the timeout value in
seconds. If no timeout value is specified, the global value is used. The
<timeout> parameter
has a range of 1-30 and is the timeout value in seconds.
Format
timeout <timeout>
Mode TACACS Config
show tacacs
Use the show tacacs command to display the configuration and statistics of a TACACS+
server.
Format
show tacacs [<ip-address>]
Mode Privileged EXEC
IP address The IP address of the configured TACACS+ server.
Port The configured TACACS+ server port number.
TimeOut The timeout in seconds for establishing a TCP connection.
Priority The preference order in which TACACS+ servers are contacted. If a server
connection fails, the next highest priority server is contacted.
Configuration Scripting Commands
Configuration Scripting allows you to generate text-formatted script files representing the
current configuration of a system. You can upload these configuration script files to a PC or
UNIX system and edit them. Then, you can download the edited files to the system and apply
the new configuration. You can apply configuration scripts to one or more switches with no or
minor modifications.
Use the
show running-config command (see “show running-config” on page 267) to capture
the running configuration into a script. Use the
copy command (see “copy” on page 275) to
transfer the configuration script to or from the switch.
You should use scripts on systems with default configuration; however, you are not prevented
from applying scripts on systems with non-default configurations.
Scripts must conform to the following rules:
• The file extension must be “.scr”.
• A maximum of ten scripts are allowed on the switch.
• The combined size of all script files on the switch shall not exceed 2048 KB.
• The maximum number of configuration file command lines is 2000.
You can type single-line annotations at the command prompt to use when you write test or
configuration scripts to improve script readability. The exclamation point (!) character flags
the beginning of a comment. The comment flag character can begin a word anywhere on the
command line, and all input following this character is ignored. Any command line that begins
with the “!” character is recognized as a comment line and ignored by the parser.