162 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
Mode Network Config
no radius server host
The no version of this command deletes the configured RADIUS authentication server IP
address.
Format no radius server host
Mode Network Config
radius server secret
This command configures the secret to use in communicating with the configured RADIUS
server. The secret must be a printable string in the range 0-64 characters. When the command
is entered, you will be prompted to enter the secret and then again to confirm the secret.
Format
radius server secret
Mode Network Config
radius accounting
This command enables RADIUS accounting mode for authentication on this network.
Default Disable
Format
radius accounting
Mode Network Config
no radius accounting
The no version of this command disables RADIUS accounting mode for authentication on this
network.
Format
no radius accounting
Mode Network Config
wpa versions
This command configures the WPA version(s) supported on the network. One or both
parameters must be specified. This configuration only applies when the configured security
mode is WPA.
Default wpa/wpa2
Format
wpa version {wpa [wpa2] | wpa2}
Mode Network Config
wpa WPA version allowed.
wpa2 WPA2 version allowed.
To Next Page
Loading...
Need help?
General
