D-Link DWL-3500AP

182 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
Long Retry Limit Indicates the maximum number of transmission attempts on frame sizes
greater than the RTS Threshold. This is a read-only value and cannot be con-
figured.
Maximum Transmit Lifetime Indicates the elapsed time after the initial transmission of an
MSDU, after which further attempts to transmit the MSDU shall be termi-
nated. This is a read-only value and cannot be configured.
Maximum Receive Lifetime Indicates the elapsed time after the initial reception of a frag-
mented MMPDU or MSDU, after which further attempts to reassemble the
MMPDU or MSDU shall be terminated. This is a read-only value and cannot
be configured.
Maximum Clients Maximum number of simultaneous associations allowed on the interface.
Automatic Channel Adjustment Indicates if automatic channel adjustment is enabled. If
enabled, the initial AP channel assignment can be automatically adjusted by
the switch due to changes in the network.
802.11a Limit Channel Selection Indicates if the auto channel algorithm will limit the
802.11a channel selection to a pre-defined set of values. This value is only
displayed for 802.11a mode.
Automatic Power Adjustment Indicates if automatic power adjustment is enabled. If
enabled, the switch may modify the power on the radio due to changes in per-
formance.
Default Power Indicates a default power setting for the radio. If automatic power adjustment
is disabled, this indicates a fixed power setting, otherwise it indicates the ini-
tial power setting before any automatic adjustments.
Supported Rates Indicates what data rates the AP will support in setting up communications
with client stations.
Advertised Rates Indicates what data rates the AP will advertise to clients in its beacons.
Load Balancing Indicates if the AP will load balance users on this radio.
Load Utilization If load balancing is enabled, % of network utilization allowed on the radio
before clients are denied.
Station Isolation Indicates whether Station Isolation is enabled. When Station Isolation is
enabled, the AP blocks communication between wireless stations.
show wireless rates
This command displays the rates valid for a specified physical mode. This is intended to help
you determine valid values for the
radio configuration command.
Format
show wireless rates {a | b | g | prime-a | prime-g | turbo-a |
turbo-g}
Mode Privileged EXEC
Mode Indicates the physical layer technology to use on the radio.
Val id Rat es Indicates data rates valid for the physical mode.