130 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
Format show ip vlan
Modes Privileged EXEC
User EXEC
MAC Address used by Routing VLANs The MAC Address associated with the internal
bridge-router interface (IBRI). The same MAC Address is used by all VLAN
routing interfaces. It will be displayed above the per-VLAN information.
VLAN ID The identifier of the VLAN.
Logical Interface The logical slot/port associated with the VLAN routing interface.
IP Address The IP address associated with this VLAN.
Subnet Mask The subnet mask that is associated with this VLAN.
Virtual Router Redundancy Protocol
Commands
This section describes the commands you use to view and configure Virtual Router
Redundancy Protocol (VRRP) and to view VRRP status information. VRRP helps provide
failover and load balancing when you configure two devices as a VRRP pair.
ip vrrp (Global Config)
Use this command in Global Config mode to enable the administrative mode of VRRP on the
router.
Default none
Format
ip vrrp
Mode Global Config
no ip vrrp
Use this command in Global Config mode to disable the default administrative mode of VRRP
on the router.
Format
no ip vrrp
Mode Global Config
ip vrrp (Interface Config)
Use this command in Interface Config mode to create a virtual router associated with the
interface. The parameter
<vrid> is the virtual router ID, which has an integer value range from
1 to 255.
Format
ip vrrp <vrid>
Mode Interface Config
no ip vrrp
Use this command in Interface Config mode to delete the virtual router associated with the
interface. The virtual Router ID,
<vrid>, is an integer value that ranges from 1 to 255.
To Next Page
Loading...
