D-Link DWL-3500AP

296 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
Format show network
Modes Privileged EXEC
User EXEC
IP Address The IP address of the interface. The factory default value is 0.0.0.0
Subnet Mask The IP subnet mask for this interface. The factory default value is 0.0.0.0
Default Gateway The default gateway for this IP interface. The factory default value is
0.0.0.0
Burned In MAC Address The burned in MAC address used for in-band connectivity.
Locally Administered MAC Address If desired, a locally administered MAC address can be
configured for in-band connectivity. To take effect, 'MAC Address Type' must
be set to 'Locally Administered'. Enter the address as twelve hexadecimal dig-
its (6 bytes) with a colon between each byte. Bit 1 of byte 0 must be set to a 1
and bit 0 to a 0, i.e. byte 0 should have the following mask 'xxxx xx10'. The
MAC address used by this bridge when it must be referred to in a unique fash-
ion. It is recommended that this be the numerically smallest MAC address of
all ports that belong to this bridge. However it is only required to be unique.
When concatenated with dot1dStpPriority a unique BridgeIdentifier is formed
which is used in the Spanning Tree Protocol.
MAC Address Type The MAC address which should be used for in-band connectivity. The
choices are the burned in or the Locally Administered address. The factory
default is to use the burned in MAC address.
Network Configuration Protocol Current The network protocol being used. The options
are bootp | dhcp | none.
Java Mode Specifies if the switch should allow access to the Java applet in the header
frame. Enabled means the applet can be viewed. The factory default is
enabled.
Web Mode Specifies if the switch should allow access to the Web Interface. The factory
default is enabled.
show serviceport
This command displays service port configuration information.
Format
show serviceport
Mode Privileged EXEC
IP Address The IP address of the interface. The factory default value is 0.0.0.0
Subnet Mask The IP subnet mask for this interface. The factory default value is 0.0.0.0
Default Gateway The default gateway for this IP interface. The factory default value is
0.0.0.0
ServPort Configuration Protocol Current The network protocol used on the last, or current
power-up cycle, if any.
Burned in MAC Address The burned in MAC address used for in-band connectivity.