System Utility and Clear Commands 273
6 Utility Commands
clear counters
This command clears the statistics for a specified <slot/port>, for all the ports, or for the
entire switch based upon the argument.
Format
clear counters {<slot/port> | all}
Mode Privileged EXEC
clear igmpsnooping
This command clears the tables managed by the IGMP Snooping function and attempts to
delete these entries from the Multicast Forwarding Database.
Format
clear igmpsnooping
Mode Privileged EXEC
clear pass
This command resets all user passwords to the factory defaults without powering off the
switch. You are prompted to confirm that the password reset should proceed.
Format
clear pass
Mode Privileged EXEC
clear port-channel
This command clears all port-channels (LAGs).
Format
clear port-channel
Mode Privileged EXEC
clear traplog
This command clears the trap log.
Format
clear traplog
Mode Privileged EXEC
clear vlan
This command resets VLAN configuration parameters to the factory defaults.
Format
clear vlan
Mode Privileged EXEC
enable passwd
This command prompts you to change the Privileged EXEC password. Passwords are a
maximum of eight alphanumeric characters. The password is case sensitive.
To Next Page
Loading...
