108 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
lldp notification-interval
Use this command to configure how frequently the system sends remote data change
notifications. The
<interval> parameter is the number of seconds to wait between sending
notifications. The valid interval range is 5-3600 seconds.
Default 5
Format
lldp notification-interval <interval>
Mode Global Config
no lldp notification-interval
Use this command to return the notification interval to the default value.
Format
no lldp notification-interval
Mode Global Config
clear lldp statistics
Use this command to reset all LLDP statistics.
Format
clear lldp statistics
Mode Privileged Exec
clear lldp remote-data
Use this command to delete all information from the LLDP remote data table.
Format
clear lldp remote-data
Mode Global Config
show lldp
Use this command to display a summary of the current LLDP configuration.
Format
show lldp
Mode Privileged EXEC
Transmit Interval How frequently the system transmits local data LLDPDUs, in seconds.
Transmit Hold Multiplier The multiplier on the transmit interval that sets the TTL in local
data LLDPDUs.
Re-initialization Delay The delay before re-initialization, in seconds.
Notification Interval How frequently the system sends remote data change notifications, in
seconds.
show lldp interface
Use this command to display a summary of the current LLDP configuration for a specific
interface or for all interfaces.
To Next Page
Loading...
