D-Link DWL-3500AP

278 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
Format sntp client port <portid>
Mode Global Config
no sntp client port
This command resets the SNTP client port back to its default value.
Format.
no sntp client port
Mode Global Config
sntp unicast client poll-interval
This command sets the poll interval for SNTP unicast clients in seconds as a power of two
where
<poll-interval> can be a value from 6 to 16.
Default 6
Format
sntp unicast client poll-interval <poll-interval>
Mode Global Config
no sntp unicast client poll-interval
This command resets the poll interval for SNTP unicast clients to its default value.
Format
no sntp unicast client poll-interval
Mode Global Config
sntp unicast client poll-timeout
This command will set the poll timeout for SNTP unicast clients in seconds to a value from 1-
30.
Default 5
Format
sntp unicast client poll-timeout <poll-timeout>
Mode Global Config
no sntp unicast client poll-timeout
This command will reset the poll timeout for SNTP unicast clients to its default value.
Format
no sntp unicast client poll-timeout
Mode Global Config
sntp unicast client poll-retry
This command will set the poll retry for SNTP unicast clients to a value from 0 to 10.
Default 1
Format
sntp unicast client poll-retry <poll-retry>
Mode Global Config