D-Link DWL-3500AP

310 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
snmp-server
This command sets the name and the physical location of the switch, and the organization
responsible for the network. The range for
<name>, <loc> and <con> is from 1 to 31
alphanumeric characters.
Default none
Format
snmp-server {sysname <name> | location <loc> | contact <con>}
Mode Global Config
snmp-server community
This command adds (and names) a new SNMP community. A community <name> is a name
associated with the switch and with a set of SNMP managers that manage it with a specified
privileged level. The length of
<name> can be up to 16 case-sensitive characters.
NOTE: Community names in the SNMP Community Table must be unique. When
making multiple entries using the same community name, the first entry is
kept and processed and all duplicate entries are ignored.
Default public and private, which you can rename
default values for the remaining four community names are blank
Format
snmp-server community <name>
Mode Global Config
no snmp-server community
This command removes this community name from the table. The <name> is the community
name to be deleted.
Format
no snmp-server community <name>
Mode Global Config
snmp-server community ipaddr
This command sets a client IP address for an SNMP community. The address is the associated
community SNMP packet sending address and is used along with the client IP mask value to
denote a range of IP addresses from which SNMP clients may use that community to access
the device. A value of 0.0.0.0 allows access from any IP address. Otherwise, this value is
ANDed with the mask to determine the range of allowed client IP addresses. The name is the
applicable community name.
Default 0.0.0.0
Format
snmp-server community ipaddr <ipaddr> <name>
Mode Global Config
no snmp-server community ipaddr
This command sets a client IP address for an SNMP community to 0.0.0.0. The name is the
applicable community name.