D-Link DWL-3500AP

308 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
users snmpv3 accessmode
This command specifies the snmpv3 access privileges for the specified login user. The valid
accessmode values are
readonly or readwrite. The <username> is the login user name for
which the specified access mode applies. The default is
readwrite for the “admin” user and
readonly for all other users. You must enter the <username> in the same case you used when
you added the user. To see the case of the
<username>, enter the show users command.
Default admin - readwrite
other - readonly
Format
users snmpv3 accessmode <username> {readonly | readwrite}
Mode Global Config
no users snmpv3 accessmode
This command sets the snmpv3 access privileges for the specified user as readwrite for the
“admin” user and readonly for all other users. The
<username> value is the user name for
which the specified access mode will apply.
Format
no users snmpv3 accessmode <username>
Mode Global Config
users snmpv3 authentication
This command specifies the authentication protocol to be used for the specified user. The valid authentication
protocols are none, md5 or sha.
If you specify md5 or sha, the login password is also used as the
snmpv3 authentication password and therefore must be at least eight characters in length. The
<username> is the user name associated with the authentication protocol. You must enter the
<username> in the same case you used when you added the user. To see the case of the
<username>, enter the show users command.
Default no authentication
Format
users snmpv3 authentication <username> {none | md5 | sha}
Mode Global Config
no users snmpv3 authentication
This command sets the authentication protocol to be used for the specified user to none. The
<username> is the user name for which the specified authentication protocol is used.
Format
no users snmpv3 authentication <username>
Mode Global Config
users snmpv3 encryption
This command specifies the encryption protocol used for the specified user. The valid
encryption protocols are
des or none.
If you select
des, you can specify the required key on the command line. The encryption key
must be 8 to 64 characters long. If you select the des protocol but do not provide a key, the
user is prompted for the key. When you use the
des protocol, the login password is also used