Address Resolution Protocol (ARP) Commands 119
3 Routing Commands
no arp dynamicrenew
This command prevents dynamic ARP entries from renewing when they age out.
Format
no arp dynamicrenew
Mode Privileged EXEC
arp purge
This command causes the specified IP address to be removed from the ARP cache. Only
entries of type dynamic or gateway are affected by this command.
Format
arp purge <ipaddr>
Mode Privileged EXEC
arp resptime
This command configures the ARP request response timeout.
The value for
<seconds> is a valid positive integer, which represents the IP ARP entry
response timeout time in seconds. The range for
<seconds> is between 1-10 seconds.
Default 1
Format
arp resptime <1-10>
Mode Global Config
no arp resptime
This command configures the default ARP request response timeout.
Format
no arp resptime
Mode Global Config
arp retries
This command configures the ARP count of maximum request for retries.
The value for
<retries> is an integer, which represents the maximum number of request for
retries. The range for
<retries> is an integer between 0-10 retries.
Default 4
Format
arp retries <0-10>
Mode Global Config
no arp retries
This command configures the default ARP count of maximum request for retries.
Format
no arp retries
Mode Global Config
To Next Page
Loading...
