180 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
no rate
The no version of this command is used to remove an advertised or supported data rate from
the corresponding list.
Format
no rate {advertised | supported} <value>
Mode AP Profile Radio Config
value A valid rate based on radio mode.
wmm
This command enables WMM mode for the radio. WMM mode is Wi-Fi Multimedia mode.
When enabled QoS settings affect both downstream traffic to the station (AP EDCA
parameters) and upstream traffic to the AP (station EDCA parameters). When disabled QoS
only applies to downstream traffic.
Default Enabled
Format
wmm
Mode AP Profile Radio Config
no wmm
The no version of this command disables WMM mode for the radio.
Format
no wmm
Mode AP Profile Radio Config
load-balance
This command enables load balancing. The optional utilization parameter indicates the
percentage of network utilization allowed on the radio before clients are denied. 0% indicates
that no load balancing is performed.
Default Disabled
utilization, 60%
Format
load-balance [utilization <1-100>]
Mode AP Profile Radio Config
1-100 Percentage of network utilization allowed on the radio
no load-balance
The no version of this command disables load balancing or resets the utilization to its default
value. If no parameters are entered, load balancing is disabled.
Format
no load-balance [utilization]
Mode AP Profile Radio Config
To Next Page
Loading...
