128 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
Mode Privileged EXEC
User EXEC
Route Codes The key for the routing protocol codes that might appear in the routing table
output.
The
show ip route command displays the routing tables in the following format:
Code IP-Address/Mask [Preference/Metric] via Next-Hop, Interface
The columns for the routing table display the following information:
Code The codes for the routing protocols that created the routes.
IP-Address/Mask The IP-Address and mask of the destination network corresponding to this
route.
Preference The administrative distance associated with this route. Routes with low values
are preferred over routes with higher values.
Metric The cost associated with this route.
via Next-Hop The outgoing router IP address to use when forwarding traffic to the next
router (if any) in the path toward the destination
Interface The outgoing router interface to use when forwarding traffic to the next desti-
nation
show ip route summary
Use this command to display the routing table summary. Use the optional all parameter to
show the number of all routes, including best and non-best routes. To include only the number
of best routes, do not use the optional parameter.
Format
show ip route summary [all]
Mode Privileged EXEC
User EXEC
Connected Routes The total number of connected routes in the routing table.
Static Routes Total number of static routes in the routing table.
RIP Routes Total number of routes installed by RIP protocol.
BGP Routes Total number of routes installed by BGP protocol.
OSPF Routes Total number of routes installed by OSPF protocol.
Total Routes Total number of routes in the routing table.
show ip route preferences
This command displays detailed information about the route preferences. Route preferences
are used in determining the best route. Lower router preference values are preferred over
higher router preference values. A route with a preference of 255 cannot be used to forward
traffic.
Format
show ip route preferences
Modes Privileged EXEC
To Next Page
Loading...
