84 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
no storm-control broadcast all
This command disables broadcast storm recovery mode for all interfaces.
Format
no storm-control broadcast all
Mode Global Config
storm-control broadcast all level
This command configures the broadcast storm recovery threshold in terms of percentage of the
interface speed for all interfaces. If the mode is enabled, broadcast storm recovery is active,
and if the rate of L2 broadcast traffic ingressing on an interface increases beyond the
configured threshold, the traffic will be dropped. Therefore, the rate of broadcast traffic will be
limited to the configured threshold.This command also enables broadcast storm recovery
mode for all interfaces.
Default 5
Format
storm-control broadcast all level <0-100>
Mode Global Config
no storm-control broadcast all level
This command sets the broadcast storm recovery threshold to the default value for all
interfaces and disables broadcast storm recovery.
Format
no storm-control broadcast all level
Mode Global Config
storm-control multicast
This command enables multicast storm recovery mode for an interface. If the mode is enabled,
multicast storm recovery is active, and if the rate of L2 multicast traffic ingressing on an
interface increases beyond the configured threshold, the traffic will be dropped. Therefore, the
rate of multicast traffic will be limited to the configured threshold.
Default disabled
Format
storm-control multicast
Mode Interface Config
no storm-control multicast
This command disables multicast storm recovery mode for an interface.
Format
no storm-control multicast
Mode Interface Config
storm-control multicast level
This command configures the multicast storm recovery threshold in terms of percentage of the
interface speed for an interface and enables multicast storm recovery mode. If the mode is
To Next Page
Loading...
