Simple Network Time Protocol (SNTP) Commands 279
6 Utility Commands
no sntp unicast client poll-retry
This command will reset the poll retry for SNTP unicast clients to its default value.
Format
no sntp unicast client poll-retry
Mode Global Config
sntp multicast client poll-interval
This command will set the poll interval for SNTP multicast clients in seconds as a power of
two where
<poll-interval> can be a value from 6 to 16.
Default 6
Format
sntp multicast client poll-interval <poll-interval>
Mode Global Config
no sntp multicast client poll-interval
This command resets the poll interval for SNTP multicast clients to its default value.
Format
no sntp multicast client poll-interval
Mode Global Config
sntp server
This command configures an SNTP server (a maximum of three). The optional priority can be
a value of 1-3, the version a value of 1-4, and the port id a value of 1-65535.
Format
sntp server <ipaddress> [<priority> [<version> [<portid>]]]
Mode Global Config
no sntp server
This command deletes an server from the configured SNTP servers.
Format
no sntp server remove <ipaddress>
Mode Global Config
show sntp
This command is used to display SNTP settings and status.
Format
show sntp
Mode Privileged EXEC
Last Update Time Time of last clock update.
Last Attempt Time Time of last transmit query (in unicast mode).
Last Attempt Status Status of the last SNTP request (in unicast mode) or unsolicited mes-
sage (in broadcast mode).
To Next Page
Loading...
