37
2
Switching Commands
This chapter describes the switching commands available in the D-Link Unified Wired/
Wireless Access System CLI.
The Switching Commands chapter includes the following sections:
• “Port Configuration Commands” on page 38
• “Spanning Tree Protocol (STP) Commands” on page 41
• “VLAN Commands” on page 52
• “Double VLAN Commands” on page 62
• “Provisioning (IEEE 802.1p) Commands” on page 64
• “Protected Ports Commands” on page 65
• “GARP Commands” on page 67
• “GVRP Commands” on page 69
• “GMRP Commands” on page 70
• “Port-Based Network Access Control Commands” on page 72
• “Storm-Control Commands” on page 82
• “Port-Channel/LAG (802.3ad) Commands” on page 88
• “Port Mirroring” on page 93
• “IGMP Snooping Configuration Commands” on page 97
• “Port Security Commands” on page 103
• “LLDP (802.1AB) Commands” on page 105
• “Denial of Service Protection Commands” on page 111
• “MAC Database Commands” on page 114
CAUTION: The commands in this chapter are in one of three functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every configu-
ration command, there is a show command that displays the configuration setting.
• Clear commands clear some or all of the settings to factory defaults.
To Next Page
Loading...
