86 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
no storm-control multicast all level
This command sets the multicast storm recovery threshold to the default value for all
interfaces and disables multicast storm recovery.
Format.
no storm-control multicast all level
Mode Global Config
storm-control unicast
This command enables unicast storm recovery mode for an interface. If the mode is enabled,
unicast storm recovery is active, and if the rate of unknown L2 unicast (destination lookup
failure) traffic ingressing on an interface increases beyond the configured threshold, the traffic
will be dropped. Therefore, the rate of unknown unicast traffic will be limited to the
configured threshold.
Default disabled
Format
storm-control unicast
Mode Interface Config
no storm-control unicast
This command disables unicast storm recovery mode for an interface.
Format.
no storm-control unicast
Mode Interface Config
storm-control unicast level
This command configures the unicast storm recovery threshold in terms of percentage of the
interface speed for an interface, and enables unicast storm recovery. If the mode is enabled,
unicast storm recovery is active, and if the rate of unknown L2 unicast (destination lookup
failure) traffic ingressing on an interface increases beyond the configured threshold, the traffic
will be dropped. Therefore, the rate of unknown unicast traffic will be limited to the
configured threshold.This command also enables unicast storm recovery mode for an
interface.
Default 5
Format
storm-control unicast level <0-100>
Mode Interface Config
no storm-control unicast level
This command sets the unicast storm recovery threshold to the default value for an interface
and disables unicast storm recovery.
Format
no storm-control unicast level
Mode Interface Config
To Next Page
Loading...
