139
4
Wireless Commands
This chapter describes the CLI commands you use to manage the wireless features on the
switch as well as the wireless access points that a switch manages.
This chapter contains the following sections:
• “Unified Switch Commands” on page 140
• “Unified Switch Channel and Power Commands” on page 149
• “Peer Unified Switch Commands” on page 154
• “Local Access Point Database Commands” on page 155
• “Wireless Network Commands” on page 158
• “Access Point Profile Commands” on page 169
• “Access Point Profile RF Commands” on page 173
• “Access Point Profile QoS Commands” on page 183
• “Access Point Profile VAP Commands” on page 185
• “Switch Managed Access Point Commands” on page 186
• “Access Point Failure Status Commands” on page 197
• “RF Scan Access Point Status Commands” on page 198
• “Client Association Status and Statistics Commands” on page 199
• “Client Failure and Ad Hoc Status Commands” on page 202
• “Captive Portal Global Commands” on page 204
• “Captive Portal Configuration Commands” on page 206
• “Captive Portal Status Commands” on page 213
• “Captive Portal Client Connection Commands” on page 215
• “Captive Portal Interface Commands” on page 218
• “Captive Portal Local User Commands” on page 219
• “Captive Portal User Group Commands” on page 224
• “Captive Portal Activity Log Commands” on page 224
The commands in this chapter are in one of three functional groups:
• Show commands display switch settings, statistics and other information.
• Configuration Commands configure features and options. For every configuration com-
mand there is a show command that displays the configuration setting.
• Clear commands clear some or all of the settings to factory defaults.
To Next Page
Loading...
