EasyManua.ls Logo

D-Link DWL-3500AP

D-Link DWL-3500AP
344 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
System Information and Statistics Commands 263
6 Utility Commands
Packets Transmitted 512-1023 Octets - The total number of packets (includ-
ing bad packets) received that were between 512 and 1023 octets in length
inclusive (excluding framing bits but including FCS octets).
Packets Transmitted 1024-1518 Octets - The total number of packets
(including bad packets) received that were between 1024 and 1518 octets in
length inclusive (excluding framing bits but including FCS octets).
Max Frame Size - The maximum size of the Info (non-MAC) field that this
port will receive or transmit.
Packets Transmitted Successfully
Tot al - The number of frames that have been transmitted by this port to its
segment.
Unicast Packets Transmitted - The total number of packets that higher-level
protocols requested be transmitted to a subnetwork-unicast address, including
those that were discarded or not sent.
Multicast Packets Transmitted - The total number of packets that higher-
level protocols requested be transmitted to a Multicast address, including
those that were discarded or not sent.
Broadcast Packets Transmitted - The total number of packets that higher-
level protocols requested be transmitted to the Broadcast address, including
those that were discarded or not sent.
Transmit Errors
Tot al Er ror s - The sum of Single, Multiple, and Excessive Collisions.
Tx FCS Errors - The total number of packets transmitted that had a length
(excluding framing bits, but including FCS octets) of between 64 and 1518
octets, inclusive, but had a bad Frame Check Sequence (FCS) with an integral
number of octets
Oversized - The total number of frames that exceeded the max permitted
frame size. This counter has a max increment rate of 815 counts per sec. at 10
Mb/s.
Underrun Errors - The total number of frames discarded because the trans-
mit FIFO buffer became empty during frame transmission.
Transmit Discards
Tot al Dis car ds - The sum of single collision frames discarded, multiple colli-
sion frames discarded, and excessive frames discarded.
Total Output Packets Dropped - The total number of Aged packets.
Single Collision Frames - A count of the number of successfully transmitted
frames on a particular interface for which transmission is inhibited by exactly
one collision.
Multiple Collision Frames - A count of the number of successfully transmit-
ted frames on a particular interface for which transmission is inhibited by
more than one collision.
Excessive Collisions - A count of frames for which transmission on a particu-
lar interface fails due to excessive collisions.

Table of Contents

Other manuals for D-Link DWL-3500AP

Related product manuals