D-Link DWL-3500AP

Port-Based Network Access Control Commands 81
2 Switching Commands
Server Timeout The timer used by the authenticator on this port to timeout the authentication
server. The value is expressed in seconds and will be in the range of 1 and
65535.
Maximum Requests The maximum number of times the authenticator state machine on this
port will retransmit an EAPOL EAP Request/Identity before timing out the
supplicant. The value will be in the range of 1 and 10.
VLAN Assigned The VLAN ID assigned by the RADIUS server.
Reauthentication Period The timer used by the authenticator state machine on this port to
determine when reauthentication of the supplicant takes place. The value is
expressed in seconds and will be in the range of 1 and 65535.
Reauthentication Enabled Indicates if reauthentication is enabled on this port. Possible val-
ues are ‘True” or “False”.
Key Transmission Enabled Indicates if the key is transmitted to the supplicant for the speci-
fied port. Possible values are True or False.
Control Direction The control direction for the specified port or ports. Possible values are
both or in.
Example:
The following shows example CLI display output for the command.
(DWS-3026) #show dot1x detail 0/1
Port........................................... 0/1
Protocol Version............................... 1
PAE Capabilities............................... Authenticator
Authenticator PAE State........................ Initialize
Backend Authentication State................... Initialize
Quiet Period................................... 60
Transmit Period................................ 30
Guest VLAN ID.................................. 0
Guest Vlan Period.............................. 90
Supplicant Timeout............................. 30
Server Timeout (secs).......................... 30
Maximum Requests............................... 2
Vlan Assigned.................................. 0
Reauthentication Period........................ 3600
Reauthentication Enabled....................... FALSE
Key Transmission Enabled....................... FALSE
Control Direction.............................. both
If you use the optional parameter statistics <slot/port>, the following dot1x statistics for
the specified port appear.
Port The interface whose statistics are displayed.
EAPOL Frames Received The number of valid EAPOL frames of any type that have been
received by this authenticator.
EAPOL Frames Transmitted The number of EAPOL frames of any type that have been
transmitted by this authenticator.
EAPOL Start Frames Received The number of EAPOL start frames that have been received
by this authenticator.
EAPOL Logoff Frames Received The number of EAPOL logoff frames that have been
received by this authenticator.