MLD Snooping Rate Limit Settings
This window is used to configure the rate of MLD control packets that are allowed per port or per VLAN.
To view this window, click L2 Features > MLD Snooping > MLD Snooping Rate Limit Settings, as shown below:
Figure 3 - 54 MLD Snooping Rate Limit Settings window
The following parameters may be viewed or modified:
Parameter Description
Port List
Specifies a port or range ports to configure or display.
VLAN List
Specifies a VLAN or range of VLANs to configure or display.
Rate Limit
Specifies the rate of MLD control packets that the switch can process on a specific port or
VLAN. The rate is specified in packets per second. The packet that exceeds the limited rate
will be dropped. Tick the No Limit check box for unlimited rate.
Click Apply to implement new changes.
To Next Page
Loading...
Need help?
General