IMP Binding Global Settings
This window is used to enable or disable the Trap Log State and DHCP Snoop state on the switch. The Trap/Log field
will enable and disable the sending of trap log messages for IP-MAC binding. When enabled, the Switch will send a
trap message to the SNMP agent and the Switch log when an ARP packet is received that doesn’t match the IP-MAC
binding configuration set on the Switch.
To view this window click, Security > IP-MAC-Port Binding > IMP Binding Global Settings
Figure 6 - 4 IMP Binding Global Settings window
The following parameters can be set:
Parameter Description
Trap / Log
This field will enable and disable the sending of trap log messages for IP-MAC binding. When
enabled, the Switch will send a trap log message to the SNMP agent and the Switch log
when an ARP packet is received that doesn’t match the IP-MAC binding configuration set on
the Switch.
DHCP Snoop State
Use the pull-down menu to enable or disable the DHCP Snoop State for IP-MAC Binding.
Click Apply to implement the settings made.