Click Apply to implement changes made.
Serial Port Settings
The following window contains information about the Serial Port Settings to view this window click Configuration >
Serial Port Settings.
Figure 2 - 3 Serial Port Settings window
Parameter Description
Baud Rate
This field specifies the baud rate for the serial port on the Switch. There are four possible
baud rates to choose from, 9600, 19200, 38400 and 115200. For a connection to the Switch
using the CLI interface, the baud rate must be set to 115200, which is the default setting.
Auto Logout
Select the logout time used for the console interface. This automatically logs the user out after
an idle period of time, as defined. Choose from the following options: 2 Minutes, 5 Minutes, 10
Minutes, 15 Minutes or Never. The default setting is 10 minutes.
Click Apply to implement changes made.
IP Address
The IP address may initially be set using the console interface prior to connecting to it through the Ethernet. If the
Switch IP address has not yet been changed, read the introduction of the DES-3528/DES-3552 Series CLI Manual for
more information.
Click Configuration > IP Address to display the following window:
Figure 2 - 4 IP Address Settings window
To manually assign the Switch's IP address, subnet mask, and default gateway address:
1. Select Static at the top of the screen.
2. Enter the appropriate IP Address and Subnet Mask.
3. If you want to access the Switch from a different subnet from the one it is installed on, enter the IP address of
the Gateway. If you will manage the Switch from the subnet on which it is installed, you can leave the default
address (0.0.0.0) in this field.
4. If no VLANs have been previously configured on the Switch, you can use the default VLAN Name. The default
VLAN contains all of the Switch ports as members. If VLANs have been previously configured on the Switch,
To Next Page
Loading...
Need help?
General