RADIUS Authorization
Used to enable or disable the accepting of authorized configuration. When this is
enabled, the authorized data assigned by the RADUIS server will be accepted if the
global authorization network is enabled.
Local Authorization
Used to enable or disable the accepting of authorized configuration. When this is
enabled, the authorized data assigned by the local database will be accepted.
Config Guest VLAN
VLAN Name / VLAND ID
(1-4094)
Toggled between VLAN Name and VLAN ID to enter one of the previously configured
guest VLAN.
Member Ports (e.g.: 1-5, 9)
Enter the list of ports that have been configured for the Guest VLAN.
Port Settings
From Port / To Port
Enter the Port range.
State
Use the pull-down menu to enable or disable the MAC-based Access Control function
on individual ports.
Mode Select the mode as Host Based or Port Based. If configured as Host Based, each
user can have its own authentication result. If configured as Port Based, all users
connected to the prot will share the first authentication result.
Agin Time (1-1440)
A time period during which an authenticated host will be kept in authenticated state.
When the aging time is time–out, the host will be moved back to unauthenticated state
Hold Time (1-300)
If a host fails to pass the authentication, the next authentication will not started within
the entered period of time unless the user clear the entry state manually.
Max User (1-1000) Enter the maximun number of authenticated clients for each port Tick No Limit for
unlimited users.
MAC-based Access Control Local Settings
The following window is used to set a list of MAC addresses, along with their corresponding target VLAN, which will be
authenticated for the Switch. Once a queried MAC address is matched in this table, it will be placed in the VLAN
associated with it here. The switch administrator may enter up to 128 MAC addresses to be authenticated using the
local method configured here. To enable the MAC-based Access Control Local MAC Settings on the switch, click
Security > MAC-based Access Control > MAC-based Access Control Local Settings
Figure 6 - 43 MAC-based Access Control Local MAC Settings
To add a MAC address to the local authentication list, enter the MAC address and the target VLAN name into their
appropriate fields and click Apply. To change a MAC address or a VLAN in the list, click the corresponding Edit
button. To delete a MAC address entry, enter its parameters into the appropriate fields and click Delete By MAC, to
delete a VLAN, enter its parameters into the appropriate fields and click Delete By VLAN. To search for a MAC or a
VLAN enter the information in the appropriate fields and click Find By MAC or Find By VLAN.
To Next Page
Loading...
Need help?
General