SNMP Host Table
Use the SNMP H ost T able window to set up SNMP trap recipients. To configure SNMP Host Table entries, click
Configuration > SNMP Settings > SNMP Host Table
Figure 2 - 42 SNMP Host Table window
The following parameters can set:
Parameter Description
Host IP Address
Type the IP address of the remote management station that will serve as the SNMP host
for the Switch.
User-based Security
Model
SNMPv1 - Specifies that SNMP version 1 will be used.
SNMPV2c - Specifies that SNMP version 2 will be used.
SNMPV3 - To specify that the SNMP version 3 will be used.
Security Level NoAuthNoPriv – To specify a NoAuthNoPriv security level.
AuthNoPriv - To specify an AuthNoPriv security level.
AuthPriv - To specify an AuthPriv security level.
Community String/
SNMPv3 User Name
Type in the community string or SNMPv3 user name as appropriate.
To implement your new settings, click Apply.
SNMP Engine ID
The Engine ID is a unique identifier used for SNMP V3 implementations. This is an alphanumeric string used to
identify the SNMP engine on the Switch. To display the Switch's SNMP Engine ID, click Configuration > S NMP
Settings > SNMP Engine ID
Figure 2 - 43 SNMP Engine ID window
To change the Engine ID, enter the new Engine ID in the space provided and click the Apply button.
To Next Page
Loading...
