Subnet-based VLAN Settings
The subnet-based VLAN settings are used to create, find or delete a subnet-based VLAN entry. A subnet-based
VLAN entry is an IP subnet-based VLAN classification rule. If an untagged or priority-tagged IP packet is received on
a port, its source IP address will be used to match the subnet-based VLAN entries. If the source IP is in the subnet of
an entry, the packet will be classified to the VLAN defined for this subnet.
To view this window, click L2 Features > Subnet VLAN > Subnet VLAN Settings as shown below:
Figure 3 - 16 Subnet VLAN Settings window
The following parameters can be configured:
Parameter Description
VLAN Name
The VLAN Name to be associated with the subnet.
VLAN ID
The VLAN ID to be associated with the subnet.
Priority
The priority to be associated with the subnet. Its range is 0-7.
IPv4 Network
Address
Is used to specify an IPv4 network address. The format is ipaddress/prefix length. The prefix
length of the IPv4 network address cannot be greater than 64.
Enter the appropriate information and click Add to create a new entry. To search for a particular entry enter the
appropriate information and click Find. To remove an entry click Delete. To view all entries on the Switch click Show
All. To remove all entries click Delete All.
To Next Page
Loading...
Need help?
General