Figure 6 - 39 Enable Method List window
To delete an Enable Method List defined by the user, click the the Delete button. To modify an Enable Method List,
click on its corresponding Edit button.
To define an Enable Login Method List, set the following parameters and click Apply:
Parameter Description
Method List Name
Enter a method list name defined by the user of up to 15 characters.
Priority 1, 2, 3, 4
The user may add one, or a combination of up to four of the following authentication
methods to this method list:
local_enable - Adding this parameter will require the user to be authenticated using
the local enable password database on the Switch. The user in the next section
entitled Local Enable Password must set the local enable password.
none - Adding this parameter will require no authentication to access the Switch.
radius - Adding this parameter will require the user to be authenticated using the
RADIUS protocol from a remote RADIUS server.
tacacs - Adding this parameter will require the user to be authenticated using the
TACACS protocol from a remote TACACS server.
xtacacs - Adding this parameter will require the user to be authenticated using the
XTACACS protocol from a remote XTACACS server.
tacacs+ - Adding this parameter will require the user to be authenticated using the
TACACS protocol from a remote TACACS server.
server_group - Adding a previously configured server group will require the user to
be authenticated using a user-defined server group previously configured on the
Switch.
Local Enable Password Settings
This window will configure the locally enabled password for the Enable Admin command. When a user chooses the
"local_enable" method to promote user level privileges to administrator privileges, he or she will be prompted to enter
the password configured here that is locally set on the Switch.
To view the following window, click Security > Access Authentication Control > Local Enable Password Settings
Figure 6 - 40 Configure Local Enable Password window
To set the Local Enable Password, set the following parameters and click Apply.
To Next Page
Loading...
Need help?
General