System Log Server
The Switch can send Syslog messages to up to four designated servers using the System Log Server.
To configure the system log settings click Configuration > System Log Configuration > System Log Server
Figure 2 - 11 System Log Server window
The following parameters can be set:
Parameter Description
Server ID
Syslog server settings index (1-4).
Server IP Address
The IP address of the Syslog server.
UDP Port
(514 or 6000-65535)
Type the UDP port number used for sending Syslog messages. The default is 514.
Severity
This drop-down menu allows you to select the level of messages that will be sent. The options
are Warning, Informational, and All.
Facility
Some of the operating system daemons and processes have been assigned Facility values.
Processes and daemons that have not been explicitly assigned a Facility may use any of the
"local use" facilities or they may use the "user-level" Facility. Those Facilities that have been
designated are shown in the following: Bold font indicates the facility values that the Switch is
currently employing.
Numerical Facility Code Numerical Facility Code
0
1
2
3
4
5
7
8
9
10
11
kernel messages
user-level messages
mail system
system daemons
security/authorization messages
messages generated internally by
syslog line printer subsystem
network news subsystem
UUCP subsystem
clock daemon
security/authorization messages
FTP daemon
12
13
14
15
16
17
18
19
20
21
22
23
NTP subsystem
log audit
log alert
clock daemon
local use 0 (local0)
local use 1 (local1)
local use 2 (local2)
local use 3 (local3)
local use 4 (local4)
local use 5 (local5)
local use 6 (local6)
local use 7 (local7)
Status Choose Enabled or Disabled to activate or deactivate.
To add a new entry, enter the appropriate information and click Apply.
To Next Page
Loading...
Need help?
General