To add a new Policy Route, enter a name in Policy Route Name field and click the Create button. Click the
corresponding Edit button of the entry to see the following window.
Figure 4 - 17 Policy Route Settings window - Edit
Adjust the following parameters and click Apply to set the new Policy Route, which will be displayed in the Policy
Routing Settings window.
Parameter Description
Policy Route Name
Enter a name of no more than 32 alphanumeric characters that will be used to identify this
policy route.
Profile ID (1-14)
Enter the Profile ID number of the Access Profile, previously created, which will be used to
identify packets as following this Policy Route. This access profile, along with the access rule,
must first be constructed before this policy route can be created.
Access ID (1-128)
Enter the Access ID number of the Access Rule, previously created, which will be used to
identify packets as following this Policy Route. This access rule, along with the access profile,
must first be constructed before this policy route can be created.
Next Hop IPv4
Address
This is the IP address of the Next Hop router that will have a direct connection to the Gateway
router connected to the Internet.
State
Use the pull-down menu to enable or disable this Policy Route.
To Next Page
Loading...
Need help?
General