D-Link xStack - Page 101

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
96
Parameters
<ipaddr> - Enter the IP address of the server host.
port - (Optional) The port number of the XTACACS server host.
<int 1-65535> - Enter the value between 1 and 65535. The default value is 49.
timeout - (Optional) Specify the time in second to wait for the server to reply.
<int 1-255> - Enter the value between 1 and 255. The default value is 5.
retransmit - (Optional) Specify the count for re-transmissions.
<int 1-20> - Enter the value between 1 and 20. The default value is 2.
Restrictions
Only Administrator level can issue this command.
Example
To configure the XTACACS server host:
DGS-3620-28SC:admin#config xtacacs server_host 10.1.1.224 retransmit 5
Command: config xtacacs server_host 10.1.1.224 retransmit 5
Key is meaningless for TACACS and XTACACS.
Success.
DGS-3620-28SC:admin#
4-55 config tacacs source_ipif
Description
This command is used to specify the source interface for all outgoing TACACS packets.
Format
config tacacs source_ipif [<ipif_name 12> {<ipaddr>} | none]
Parameters
<ipif_name 12> - Enter the interface name as source interface for all outgoing TACACS packets.
<ipaddr> - (Optional) Enter the IP address as source IPv4 address for all outgoing TACACS
packets.
none - Specifies to revert to the default route table for all outgoing TACACS packet.
Restrictions
Only Administrator level can issue this command.
Example
To specify a source interface for all outgoing TACACS packets: