D-Link xStack - Page 102

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
97
DGS-3620-28SC:admin#config tacacs source_ipif if_v200
Command: config tacacs source_ipif if_v200
Success.
DGS-3620-28SC:admin#
4-56 show tacacs source_ipif
Description
This command is used to display the specified source interface for all outgoing TACACS packets.
Format
show tacacs source_ipif
Parameters
None.
Restrictions
Only Administrator level can issue this command.
Example
To display the specified source interface for all outgoing TACACS packets.
DGS-3620-28SC:admin#show tacacs source_ipif
Command: show tacacs source_ipif
IP Interface : if_v200
IPv4 Address : None
DGS-3620-28SC:admin#