D-Link xStack - Page 1069

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1064
DGS-3620-28SC:admin#
94-22 show community_encryption
Description
This command is used to display the encryption state on the SNMP community string.
Format
show community_encryption
Parameters
None.
Restrictions
None.
Example
To show the encryption state on the SNMP community string:
DGS-3620-28SC:admin# show community_encryption
Command: show community_encryption
SNMP Community Encryption State : Enabled
DGS-3620-28SC:admin#
94-23 config snmp trap_port
Description
This command is used to configure the per port’s SNMP trap state. The default port trap state is
enabled for each port.
Format
config snmp trap_port [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Enter the list of ports that will be used for this configuration.
all - Specifies that all ports will be used for this configuration.
state - Specifies the per port SNMP trap state.
enable - Specifies that the per port SNMP trap state will be enabled. This is the default option.
disable - Specifies that the per port SNMP trap state will be disabled.