D-Link xStack - Page 1070

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1065
Restrictions
Only Administrator level users can issue this command.
Example
To enable the per port SNMP trap state:
DGS-3620-28SC:admin#config snmp trap_port all state enable
Command: config snmp trap_port all state enable
Success.
DGS-3620-28SC:admin#
94-24 config snmp udp_port
Description
This command is used to change the default SNMP UDP port number.
Format
config snmp udp_port <udp_port_number 0-65535>
Parameters
<udp_port_number 0-65535> - Enter the UDP port number. This value must be between 0 and
65535. The default value is 161.
Restrictions
Only Administrator level users can issue this command.
Example
To configure the UDP port number of SNMP:
DGS-3620-28SC:admin#config snmp udp_port 50000
Command: config snmp udp_port 50000
Success.
DGS-3620-28SC:admin#
94-25 show snmp trap_port
Description
This command is used to display the SNMP trap port state.