D-Link xStack - Page 1124

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1119
ip_range - Specifies the IP range of the sub-VLAN that will be used.
<ipaddr> - Enter the starting IP address used here.
to - Specifies that the next IP address will be the ending IP address.
<ipaddr> - Enter the ending IP address used here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure IP range of sub VLAN 1 to 10.1.1.1-10.1.1.3:
DGS-3620-28SC:admin# config sub_vlan vlanid 1 add ip_range 10.1.1.1 to 10.1.1.3
Command: config sub_vlan vlanid 1 add ip_range 10.1.1.1 to 10.1.1.3
Success.
DGS-3620-28SC:admin#
102-5 show super_vlan
Description
This command is used to display the super VLAN parameters.
Format
show super_vlan {[<vlan_name 32> | vlanid <vlanid 1-4094>]}
Parameters
<vlan_name 32> - (Optional) Enter the super VLAN name used here. This name can be up to 32
characters long.
vlanid - (Optional) Specifies the super VLAN ID used.
<vlanid 1-4094> - Enter the super VLAN ID used here. This value must be between 1 and
4094.
Restrictions
None.
Example
To show super VLAN: