xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1148
109-3 disable ip urpf
Description
This command is used to disable the IP URPF feature. When disabled, the hardware routing table
needs not to be searched using SIP any more. So the whole hardware routing table can be used
by IP routes.
Note: This command will not take effect until the configuration was saved and the Switch
was rebooted.
Format
disable ip urpf
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable the URPF global state:
DGS-3620-28SC:admin#disable ip urpf
Command: disable ip urpf
Save and reboot are required to make the new setting effective.
Success.
109-4 show ip urpf
Description
This command is used to display current settings of URPF.
Format
show ip urpf {por
ts <portlis
t>}
Parameters
ports - (Optional) Specifies the list of ports that will be used for this display.
<portlist> - Enter the list of ports that will be used for this display.
If no ports were specified, all the ports’ information will be displayed.
To Next Page
Loading...
Need help?
General