To Next Page

To Previous Page

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide

1149

Restrictions

None.

Example

To display the URPF settings of all the ports:

DGS-3620-28SC:admin#show ip urpf

Command: show ip urpf

URPF Global State : Disabled

Port Mode Default Route Check Port Mode Default Route Check

------ --------- ------------------- ------ --------- -------------------

1:1 Strict Enabled 1:2 Strict Enabled

1:3 Strict Enabled 1:4 Strict Enabled

1:5 Strict Enabled 1:6 Strict Enabled

1:7 Strict Enabled 1:8 Strict Enabled

1:9 Disabled Disabled 1:10 Disabled Disabled

1:11 Disabled Disabled 1:12 Disabled Disabled

1:13 Disabled Disabled 1:14 Disabled Disabled

1:15 Disabled Disabled 1:16 Disabled Disabled

1:17 Disabled Disabled 1:18 Disabled Disabled

1:19 Disabled Disabled 1:20 Disabled Disabled

1:21 Disabled Disabled 1:22 Disabled Disabled

1:23 Disabled Disabled 1:24 Disabled Disabled

1:25 Disabled Disabled 1:26 Disabled Disabled

DGS-3620-28SC:admin#

109-5 delete ip urpf ports

Description

This command is used to remove URPF checking from one or more ports. After URPF checking

was removed from one port, its mode and default route checking option will be restored to the

default value.

Format

delete ip urpf ports [<portlist> | all]

Parameters

ports - Specifies the list of ports that will be used for this configuration.

<portlist> - Enter the list of ports that will be used for this configuration.

all - Specifies that all the ports will be used for this configuration.

Restrictions

Only Administrator, Operator and Power-User level users can issue this command.

D-Link xStack Reference Guide

Other manuals for D-Link xStack