D-Link xStack - Page 1178

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1173
110-23 show broadcast_ping_reply
Description
The show broadcast_ping_reply command is used to show the broadcast ping reply state.
Format
show broadcast_ping_reply
Parameters
None.
Restrictions
None.
Example
To show broadcast ping reply state:
DGS-3620-28SC:admin# show broadcast_ping_reply
Command: show broadcast_ping_reply
Broadcast Ping Reply State: Enabled
DGS-3620-28SC:admin#
110-24 config telnet source_ipif
Description
This command is used to select an address of an interface as the source address for TELNET
client.
Format
config telnet source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr>} | none]
Parameters
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12 characters
long.
<ipaddr> - Enter the IPv4 address used here.
<ipv6addr> - Enter the IPv6 address used here.
none - Specifies to remove the specified source address.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.