xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1174
Example
To configure the IP 10.90.90.90 on the System interface as the source address:
DGS-3620-28SC:admin#config telnet source_ipif System 10.90.90.90
Command: config telnet source_ipif System 10.90.90.90
Success.
110-25 show telnet source_ipif
Description
This command is used to show the configured source address for TELNET client.
Format
show telnet source_ipif
Parameters
None.
Restrictions
None.
Example
To display the source address for the TELNET client:
DGS-3620-28SC:admin#show telnet source_ipif
Command: show telnet source_ipif
Telnet Source IP Interface Configuration:
IP Interface : System
IPv4 Address : 10.90.90.90
IPv6 Address : None
110-26 config tftp source_ipif
Description
This command is used to select an address of an interface as the source address for TFTP.
To Next Page
Loading...
