xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
118
Example
To configure access list entry:
DGS-3620-28SC:admin#config cpu access_profile profile_id 1 add access_id 1
ethernet vlan default port 1-3 deny
Command: config cpu access_profile profile_id 1 add access_id 1 ethernet vlan
default port 1-3 deny
Success.
5-11 show cpu access_profile
Description
This command is used to display the current CPU access list table.
Format
show cpu access_profile {profile_id <value 1-5>}
Parameters
profile_id - (Optional) Specify the index of an access list profile.
<value 1-5> - Enter value between 1 and 5.
Restrictions
None.
Example
To display the current CPU access list table:
DGS-3620-28SC:admin#show cpu access_profile
Command: show cpu access_profile
CPU Interface Filtering State: Disabled
CPU Interface Access Profile Table
Total Unused Rule Entries : 496
Total Used Rule Entries : 4
==============================================================================
Profile ID: 1 Type: Ethernet
Mask on
VLAN : 0xFFF
802.1p
Ethernet Type
To Next Page
Loading...
Need help?
General