xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
181
Format
create bgp aggregate_address <network_address> {summary_only | as_set}
Parameters
<network_address> - Specifies the IP network address aggregated.
summary_only - (Optional) Specifies that more specific routes will not be advertised.
as_set - (Optional) Generates an Autonomous System set path information.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To create an aggregate route of which the network address is 10.0.0.0/8, suppress more-specific
routes:
DGS-3620-28SC:admin# create bgp aggregate_address 10.0.0.0/8 summary_only
Command: create bgp aggregate_address 10.0.0.0/8 summary_only
Success.
13-9 delete bgp aggregate_address
Description
This command is used to delete an aggregate entry in a Border Gateway Protocol (BGP) database.
Format
delete bgp aggregate_address [<network_address> | all]
Parameters
<network_address> - Specifies the IP aggregated network to be deleted.
all - Delete all IP aggregated networks.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To delete an aggregate_route of which the network address is 10.0.0.0/8:
To Next Page
Loading...
