xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
182
DGS-3620-28SC:admin# delete bgp aggregate_address 10.0.0.0/8
Command: delete bgp aggregate_address 10.0.0.0/8
Success.
13-10 show bgp aggregate_address
Description
This command is used to show the aggregate entries in the Border Gateway Protocol (BGP)
database.
Format
show bgp aggregate_address {<network_address>}
Parameters
<network_address> - Specifies the IP aggregated network address.
If specific network address is not specified, all aggregated address will be displayed.
Restrictions
None. (EI Mode Only Command)
Example
To display an aggregate route of 10.0.0.0/8:
DGS-3620-28SC:admin# show bgp aggregate_address 10.0.0.0/8
Command: show bgp aggregate_address 10.0.0.0/8
Network Address Options
------------------ ----------------------
10.0.0.0/8 summary_only, as_set
Total Aggregate Address Number: 1.
13-11 create bgp network
Description
This command is used to specify the network advertised by the Border Gateway Protocol (BGP).
BGP networks can be learned from connected routes, from dynamic routing, and from static route
sources.
Format
create bgp network <network_address> {route_map <map_name 16>}
To Next Page
Loading...
Need help?
General