xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
211
13-39 show bgp as_path access_list
Description
This command displays the Autonomous System path’s access list. If a specific access list is not
specified, all AS path access lists will be displayed.
Format
show bgp as_path access_list {<list_name 16>}
Parameters
access_list - Specifies the AS path access list name.
<list_name 16> - (Optional) Enter the AS path access list name here. This name can be up to
Restrictions
None. (EI Mode Only Command)
Example
This example displays an AS path access list:
DGS-3620-28SC:admin# show bgp as_path access_list 1
Command: show bgp as_path access_list 1
BGP AS Path Access List : 1
deny (_64[6-9][0-9][0-9]_|_65[0-9][0-9][0-9]_)
permit 33
Total Filter Entries: 2
Total AS Path Access List Number: 1
13-40 create bgp community_list
Description
This command is used to create a BGP community list.
Format
create bgp community_list [standard | expanded] <list_name 16>
Parameters
standard - Creates a standard named community list.
expanded - Creates an expanded named community list.
<list_name 16> - Enter the name of the community list that will be created here. This name can
To Next Page
Loading...
Need help?
General