xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
288
Example
To display route redistributions:
DGS-3620-28SC:admin#show route redistribute
Command: show route redistribute
Route Redistribution Settings
Source Destination Type Metric RouteMapName
Protocol Protocol
-------- ------------ -------- ------------ ------------
RIP OSPF Type-2 20 N/A
Total Entries : 1
19-11 show route redistribute dst rip
Description
This command is used to display the route redistribution settings on the Switch. It displays the
redistribution with the target protocol RIP.
Format
show route redistribute dst rip {src [local | static | ospf | bgp]}
Parameters
src - (Optional) Specifies the source protocol.
static - Display the redistribution with the source static.
local - Display the redistribution with the source local.
ospf - Display the redistribution with the source OSPF.
bgp - Display the redistribution with the source BGP. (EI Mode Only Parameter)
If no parameter is specified, the system will display all route redistributions.
Restrictions
None.
Example
To display route redistributions:
To Next Page
Loading...
Need help?
General